Your Wavlink AC1200 wireless range extender might refuse to work properly because of not one, not two, but various reasons, some of which we have highlighted in this article. An improper Wavlink AC1200 setup, inadequate power supply, damaged Ethernet cable, too much distance between networking devices, technical glitches, and much more are some examples of the factors that have contributed to the Wavlink extender not working issue.
However, focusing on the reasons will only create a mess in your head, so why don’t we pay attention to the solutions? We cannot say with surety that all of them will help you out, only a few will. Also, if you do own the AC1200 model but some other model of Wavlink extender, then know that the tips mentioned below can be used for them as well.
How to Make Wavlink AC1200 Extender Work?
1. Update the AC1200 Firmware
Firmware updates are quite important for the seamless performance of the Wavlink AC1200 extender. However, if not updated on time, it can also ruin it and cause issues like the Wavlink AC1200 wireless range extender not working issue. In this case, it is advised that you update the firmware of your networking device to its latest version. Make sure that you are following the correct instructions for the execution of the process.
It is recommended that you refer to the steps given in the user manual to execute the process. Make sure that you are following the steps in the same manner as they are given in the manual. Skipping even one step will force you to continue facing the Wavlink AC1200 wireless range extender not working issue.
2. Check the Ethernet Cable
Have you used a damaged Ethernet cable to connect the networking devices? Yes? Well then, it is recommended that you change that right away. Use a non-damaged Ethernet cable to connect the Wavlink AC1200 wireless range extender to the host router. See to it that the connection which you have established is finger-tight. This can be done if you connect the ends of the cable tightly to the ports of the device.
Although this will help you to resolve the issue at hand, by any chance, if you are still going nuts because of it, then know that you have the liberty to connect the devices wirelessly. Just ensure that the distance between them is neither too much nor less. Maintain a safe distance for a seamless flow of connection.
3. Reset the Wavlink Extender
Given you reading this troubleshooting hack, we are assuming that you are still experiencing the Wavlink AC1200 wireless range extender not working issue. In this case, you should reset or restore your networking device to its default factory mode. You can put this process into action with the help of the oil pin and using it to press the reset button. Take it as a caution to not use the tip of a pen for this purpose.
Right after you have reset your device, it will reboot. Once done, configure the device from scratch. You can do Wavlink WiFi extender setup using the WPS or the manual method.
We are very sure of the fact that you will be able to resolve the Wavlink AC1200 wireless range extender not working issue after walking through the troubleshooting tips given above. By any chance, if you are still experiencing the same issue, then it is advised that you restart the networking device. Trust us, this hack might seem too easy but it has worked for many users to resolve technical issues.
To restart your Wavlink AC1200 wireless range extender, you need to turn it off, wait for some time, and then, turn it on. It is recommended that you wait enough for the LED light to become solid. Otherwise, you will be forced to restart or reboot your networking device. And we think that you do not want this.